XJRider.com

So I tried synching my carbs the other day but the needles on all the cylinders were all over the place. When I lowered the idle they smoothed out as you would expect but still not quiet enough to get an accurate reading as I would like. I had to make a little adapter to mount the hardware needed on the carbs to take the readings, perhaps they might be to blame? I made sure I had o-rings on both the adapter going into the carb and the hardware going into the adapter. I haven't done synching before but it seems easy enough once I sort out this issue. If you have any tips I would greatly appreciate it!

Thanks,
Tim