Plate thrust
Posted: Sat Mar 04, 2017 1:37 pm
Hello.
I'm new to the forum.
I have a question about this washer located between clutch boss/clutch basket. When I tok off the clutch boss it fell on the floor before I noticed which way it was. My manual stops on 1999 modell, and can't find any info on this there. I've been looking on ride92's post on rattle fix, but can't quite figure from his picture which way its going back on. Don't quite understand his explanation either (my bad english understanding..)
Can anyone tell me from my attached pictures?
Bike is a 2001 Yamaha Xj600s.
Regards Taa
I'm new to the forum.
I have a question about this washer located between clutch boss/clutch basket. When I tok off the clutch boss it fell on the floor before I noticed which way it was. My manual stops on 1999 modell, and can't find any info on this there. I've been looking on ride92's post on rattle fix, but can't quite figure from his picture which way its going back on. Don't quite understand his explanation either (my bad english understanding..)
Can anyone tell me from my attached pictures?
Bike is a 2001 Yamaha Xj600s.
Regards Taa