99 41mm fork rebuild
Posted: Sat May 14, 2016 5:16 pm
These forks have been a nightmare.
So I'm finally ready to get these rebuilt and back in the bike. However, when I fit the bottom cap screw into the damper rod, the assembly locks up. It sounds like it's jammed between two metal contacts and has 1-2mm float in it.
Any suggestions? Anything to do with the white plastic bushes on the bottom of the stanchion?
So I'm finally ready to get these rebuilt and back in the bike. However, when I fit the bottom cap screw into the damper rod, the assembly locks up. It sounds like it's jammed between two metal contacts and has 1-2mm float in it.
Any suggestions? Anything to do with the white plastic bushes on the bottom of the stanchion?