Shim Tool in Chain Galley
Posted: Thu Apr 04, 2013 1:46 pm
I was almost done with my shims. And this joyous event happened. I was using the motion pro two piece tool, and the part that holds the bucket popped out when I was using the pry bar and sprung into the chain galley. I can't see it in there, I think I might, but I'm not sure. Is there anyway to get into there? I looked in my Haynes manual, and the first step it says for removing the oil pan is to remove the engine... Great. Anyone have any other advice? I can't be the first person something like this has happened too.