XJRider.com

a_morti wrote:I seriously do believe you will be absolutely and utterly amazed at the improvement if you fit that 1/2" Honda master cylinder. I think on that bike you will struggle for the space to mount the brembo master, so go with the 1/2" off a Honda. I used the part from a 650 Revere, but any 1/2" will do it for you. The part from a Blackbird or VFR800 has a cool little pivot system to make it even nicer, too.

Some food for thought for anyone not wanting to change up the front forks but wanting better brake feel.

This combined with stainless steel braided brake lines will give you more feel compared to the stock set-up. (Single disk only.)

References:
Discussion Thread
Previous Owner who has done the mod.