XJ600 Pick Up Coil
Posted: Sat Oct 01, 2016 7:20 am
Hi
While dismantling the engine, I wanted to remove the Pick Up Coil, by holding the Rotor I undid the centre bolt which was tight as hell........
Then, Base plate, 4 Phillips screws........the main 2 screws are...blue loctited...Hell No...heheheh...Hell Yesssss...
Undid one.....but...after mashing the head of the 2nd one, now.....thinking about..100 degrees C, on the 2nd, to melt the loctite, then, try and extract......
Loctite, why.....never going to use, in my case, asking for a nightmare.......
roy
While dismantling the engine, I wanted to remove the Pick Up Coil, by holding the Rotor I undid the centre bolt which was tight as hell........
Then, Base plate, 4 Phillips screws........the main 2 screws are...blue loctited...Hell No...heheheh...Hell Yesssss...
Undid one.....but...after mashing the head of the 2nd one, now.....thinking about..100 degrees C, on the 2nd, to melt the loctite, then, try and extract......
Loctite, why.....never going to use, in my case, asking for a nightmare.......
roy