I just installed a new Motion Pro 05-0162 cable and an EBC clutch disk kit with EBC CSK14 spring set.
I had to pull the clutch actuator up out of the clutch cover and re-index it back some as the cable was very loose, not the slack in the cable is gone but its pretty hard to pull, action doesnt feel like its binding just hard to pull, are the EBC springs that much firmer than stock? Could it be the new cable " not very smooth out of the bag but not kinked" or do I have something assembled wrong?
Anyone have a picture of their clutch cover with the cable installed, I took a lot of pictures of my bike before tearing it down but dont have a good shot of the top of the clutch cover! Any ideas?
