I just got my FZR conversion done and I am getting some residual braking force on the R6 calipers while I am riding. They are nice and stiff when braking, they just don't let off completely. It makes it hard to push it around the driveway.
Any ideas? I just tried to measure the runout on the rotors, which I suspected was out, but I couldn't get a good measurement on it by just lifting the front end off the ground because the brakes were holding on too hard.
Any ideas?
Residual clamping on R6 brakes
-
Nelsonmd
- FAQ Moderator
- Posts: 1404
- Joined: Wed Nov 16, 2011 4:35 pm
- Location: Albuquerque, NM
NelsonMD's 92 XJ600 Project Thread
NelsonMD's 4Runner Build Thread (Rusted out)
2002 Suzuki V-Strom 1000 (gone)
2004 Vespa ET4 (sold)
NelsonMD's 4Runner Build Thread (Rusted out)
2002 Suzuki V-Strom 1000 (gone)
2004 Vespa ET4 (sold)